The paper tube machine requires us to clean and lubricate the paper tube equipment regularly during use. So how to properly clean and lubricate the paper tube machine? The following editor will give you a brief introduction: ①Clean the paper tube equipment. After unpacking and inspecting and disassembling the equipment, the rust inhibitor used must be removed and cleaned before assembly, and the internal iron filings, rust and dust accumulated during transportation and storage must be removed and cleaned. ②The paper tube equipment has been lubricated. After cleaning the inside and outside of the equipment, it can be lubricated. Before using lubricants, they must be tested and determined to meet the requirements. Before adding equipment, the lubricant must be filtered, and the added oil should reach the specified oil standard position; all lubricating parts and oil holes should be filled with lubricant.

How to increase the service life of paper tube machine? How to increase the service life of paper tube machine? I think this is a concern for all users, it extends the service life and saves production costs. Here I want to give you some related suggestions. Here are some brief introductions: 1. Before using the paper tube machine, you should check the condition of each component in detail to see if the electrical equipment switches are in good condition, whether the circuit is insulated, and the nut. Whether the screws are tightened and whether the protection device is safe. After checking these parts, you can proceed to the next step. 2. When cutting paper, for example, when using a ventilator to cut paper, the height of the paper tube cutter should not exceed 125 mm. The iron is tight. The machine can only cut paper, not other plates. It should be operated by two or more people, and they should cooperate with each other. When working, please do not extend the paper tube machine into the iron and blade to prevent cuts. If a special paper cutter is used, it is forbidden to reach into the rotating mandrel to prevent crushing. 3. Each device must bear special responsibility for this, no one can misappropriate it. It is strictly forbidden to place other parts of the machine during operation. Workers are not allowed to leave the workplace without authorization; 4. When wrapping, prevent pants from getting stuck in the paper feed shaft. When adjusting the machine, please pay attention to the emery wheel.